|
|

楼主 |
发表于 2009-1-26 09:56:09
|
显示全部楼层
来自: 伊朗
I had no success running HSM on this system., G6 _3 ^4 \+ k, x6 n- \& C
I just installed v3.0.53.15030 and here's the result.
m3 B; w7 K1 a3 _! O% T& q3 w3 ]' I5 b @" a. G( q( j7 s
I tried exporting geometry as STL and used it as "Geometry Source" in a parallel finish Operation.
$ w8 k$ J2 n. v; f% ~ V9 l d8 p6 `) U" o
Here's the system message.
$ n ^8 Z! @( S& Z8 P$ _* k& Q1 s% t# i: n" m+ |. ^
Information: Initializing parallel finishing strategy
5 I+ N" [4 V" `* I6 g' b: r8 _, BInformation: Ignoring associated geometry due to explicitly selected stereolithography source.9 y8 l( ?; ?. u/ f& I! q
Information: Using external stereolithography file:///D:/U/GEOM.STL (4.9Mb).
2 K2 E. D0 @( _ B/ a9 aError: Floating-point operation on denormalized operand at address 0x0b9c886d.
$ h' n- G2 j# f, e% c
6 c! i; Z8 Q" l f" L3 b$ v. N+ d3 M' t3 O6 F
Maybe the cr@ck only works for dual core systems??
; j) ?' m+ K$ D3 x H2 ~/ ` P6 l7 b( P6 v4 N' c' M
On other dual core systems it works fine. 
0 w& \1 u, s9 z1 Q/ h9 ?Any help will be much appreciated.
& E$ [( p, w1 S& j# x9 [& g$ g( h& Z
5 S1 \$ ^1 @3 `- E% i X[ 本帖最后由 ccuappz 于 2009-1-26 09:59 编辑 ] |
|