|
|
发表于 2008-1-10 02:21:35
|
显示全部楼层
来自： LAN
Guys!
, `* X- f5 _$ v6 Q7 _All you make a big mistake then allow to Install SolidWorks2008 using automatic SolidWorks Installation Manager (it is new feature in SW2008)
- x/ w. A( a6 B( U! uSolidWorks Installation Manager checks you SW-Serial and allow to install only that SW2008 configuration that registered for that SW-Serial..
! `. ]- M" U9 J, i+ { W4 [% |
! R" ]& F3 x+ ]# F# N' k4 tIt is funny but if you use a valid but not registered SW-Serial you will be allowed to install all you want manualy!
+ h1 k! S' C* \- ?0 S4 }
2 R3 ?$ Q7 T: Y. E( ^0 QSo the right way to inatall SW2008 is:0 P6 E7 X5 ^+ a1 V; Q2 g2 o4 O' N
1) Interrupt and Cancel SolidWorks Installation Manager working
, n+ s4 x0 V0 c2 C5 j1 n+ K3 G2) Browse to E:\swwi\swsetup.exe (E: is a image of SW2008 SP0.0 5,4 GB ) and run it Y1 W4 c' C$ S8 \- g) h f
% N. I2 _4 m( Y h! x9 zSo you can be able to install all SW2008 configurations ( as it was in SW2007)
" R' E, U( Q) ^$ {7 c; K2 |; N7 [+ ?
- b0 \8 i2 o! d# }! u( K% Z4 b* o0 `In the same manner you can Install all СOSMOS:: G/ H |" R' b* z4 a5 y( L9 K
: p I/ t& [2 V
COSMOSWorks
* b& F' f, g2 n2 d( fE:\cwwi\COSMOSWorks\cwsetup.exe M6 q# b8 \# S; O5 A
" ~( M, _/ u2 T, F, G& W4 [
COSMOSFloWorks
3 ?7 I- K, j( Q4 @E:\cwwi\COSMOSFloWorks\cfsetup.exe3 c2 t4 E, _: q" M2 W/ B8 w+ P
3 {- d" @9 ?) ?* C, ~: Z7 s
COSMOSMotion
* e& q6 Y+ j5 AE:\cwwi\COSMOSMotion\cmsetup.exe
3 L/ ?% c" h" N! @8 E0 T1 ^7 |% M+ M0 J( N. ]
COSMOSM$ s% p& U) I: w( O9 P
E:\cwwi\COSMOSM\cosmosmsetup.exe' r/ ?+ i- `. T
7 }8 x) L& @+ S2 b# R0 V3 g
And also dwgeditor, eDrawings, pdmwserver, swexplorer if need them... |
|
楼主
