Logopress3 v4.0 SP2.3 for SolidWorks2006(2007) (both x32 & x64 Editions) * g% b& \0 w) x( ?* M3 }; p/ G. n- p# L6 @/ K# _
Logopress3 v4.0 SP2.3 is officially certified (tested) for SW2006 (up to SP5.0 x32 & x64) and SW2007 (up to SP1.0 x32 & x64)# ]( x! X1 Z; [0 {9 ~8 t! H
but in fact can be run under SW2007 SP3.10 R6 c: U+ F% p; i! B$ r. j( P
' j: S( K' E5 {3 _) f* z
K# w( M4 T1 u; H" R" U# O7 q- DIt will be archive of 38 parts (67 Mb) + crack for SW2006(2007) x32 Edition) E: G9 \* ?& ?* C1 ?1 Q
crack for SW2006(2007) x64 Edition will be in a few days!!!+ z' r5 B$ X$ T0 {
. H8 g4 h1 ]& ]* O
Crack for SolidWorks Win x32 Edition!!! * N/ R8 x1 g, z9 ^; i% b- Q7 n* l(Crack for SolidWorks Win x64 Edition will be in a few days...)* W+ T2 _- B& l- N/ D/ t
" B" `0 T: A4 a0 ~, v% \
All work under SolidWorks x32!' h. v# Q/ O& m! B* c# d/ g, r
If you have a problems try to uncheck and check onece again Logopress3 in SolidWorks add-in...
3 t3 U" C& n7 \ ]: m4 }
I say all work! Do all that is written in readme.txt in crack... 0 c9 H; _8 @# O1 O. N/ E/ K. l: g' J9 `4 T& b
license.dat file is empty but it is right!!!
( a1 H1 P7 g: k& {* E. h* UI did not try it with SW2006 SP0.0 (I have tested it with SW2006 SP5.1 and SW2007 SP3.1 installed) but I think it could be used with all SP's of SW2006 x32
发表于 2007-5-9 04:34:02
楼主
