|
|
发表于 2008-1-10 02:21:35
|
显示全部楼层
来自： LAN
Guys!
3 X! _& D) F* Y5 ^2 S5 B" ^) ]All you make a big mistake then allow to Install SolidWorks2008 using automatic SolidWorks Installation Manager (it is new feature in SW2008)* m2 M& ]$ ?: y% J
SolidWorks Installation Manager checks you SW-Serial and allow to install only that SW2008 configuration that registered for that SW-Serial.. U6 L1 Z2 H# r [' U* V
4 t$ t; r4 a( z) N4 d" U% I
It is funny but if you use a valid but not registered SW-Serial you will be allowed to install all you want manualy!: Y+ o$ r% M% Z$ {0 j+ J6 M# S
- z4 \5 b# S. q# _4 Z) FSo the right way to inatall SW2008 is:# [* K B9 B9 e. f
1) Interrupt and Cancel SolidWorks Installation Manager working V& ?. N/ F: G: k5 d2 y
2) Browse to E:\swwi\swsetup.exe (E: is a image of SW2008 SP0.0 5,4 GB ) and run it! q1 ]" K& e. e& @
- E0 m5 M6 V7 t' }- ]8 G# N$ Z
So you can be able to install all SW2008 configurations ( as it was in SW2007)/ k; @0 C) _+ T2 ?
: @+ t! v h O/ ?
In the same manner you can Install all СOSMOS:
4 Q7 M$ ?$ x _1 ]( x% s( M2 k Q0 Z4 b9 z2 ^ O" E: B4 f
COSMOSWorks
& `' D! d8 f) _, a6 ]4 o+ PE:\cwwi\COSMOSWorks\cwsetup.exe/ N% f3 r) s Q; n+ M7 H
8 F' f, K7 A7 `: @) yCOSMOSFloWorks5 N: j4 _; r9 J
E:\cwwi\COSMOSFloWorks\cfsetup.exe, p4 l- U/ Z. ^9 C8 n
/ }2 R$ r& u1 w/ L1 a! L; T: _COSMOSMotion! I9 B, X' N& h
E:\cwwi\COSMOSMotion\cmsetup.exe
1 A( l, s/ G8 h9 ~9 {% r; K
4 U. `6 z1 W1 F$ Y6 ACOSMOSM; _& Y( {9 ?- T# R4 A7 l
E:\cwwi\COSMOSM\cosmosmsetup.exe8 i+ h& y" N: I) L
% ^! \7 |( {8 c- u5 W: FAnd also dwgeditor, eDrawings, pdmwserver, swexplorer if need them... |
|
楼主
