|
|
发表于 2008-1-10 02:21:35
|
显示全部楼层
来自： LAN
Guys! e% _/ x! r( G, I
All you make a big mistake then allow to Install SolidWorks2008 using automatic SolidWorks Installation Manager (it is new feature in SW2008)
+ O; Q( f* ~# X2 KSolidWorks Installation Manager checks you SW-Serial and allow to install only that SW2008 configuration that registered for that SW-Serial..$ y8 F! I. a9 ?5 M
: S& r2 A7 `( }) n) m2 s( J. Y
It is funny but if you use a valid but not registered SW-Serial you will be allowed to install all you want manualy!
5 ^, u3 n5 ~1 V3 t4 I6 |0 B# t3 R9 V+ \- i: `7 i
So the right way to inatall SW2008 is:* g& q4 o1 v' t
1) Interrupt and Cancel SolidWorks Installation Manager working! \2 r1 j q# M3 w7 z% U
2) Browse to E:\swwi\swsetup.exe (E: is a image of SW2008 SP0.0 5,4 GB ) and run it1 I3 r a' ]7 p* w4 _' U4 s3 ]' ]+ C
9 k, t: S; g% \$ @+ NSo you can be able to install all SW2008 configurations ( as it was in SW2007)
9 ?# Z8 v; t% l
6 Z, n6 G2 v- o2 O) J2 lIn the same manner you can Install all СOSMOS:
2 ~6 B% `- ~9 T! M
" {5 k& Z. F& \/ |; NCOSMOSWorks
2 G W9 S& O' s9 J) F4 lE:\cwwi\COSMOSWorks\cwsetup.exe
% K1 j" c+ J) [" `5 t- \2 w; z8 a4 T
COSMOSFloWorks+ r9 x* E2 h% D! n- z
E:\cwwi\COSMOSFloWorks\cfsetup.exe
) Y( N' c2 P9 n9 D1 H2 J2 v1 d. h% F6 B6 M+ D2 _$ y! B
COSMOSMotion, C3 N# O) g/ z3 |
E:\cwwi\COSMOSMotion\cmsetup.exe+ E I* S* q* a! R' e* F# \3 m
: { Y7 e& J3 C# o5 r
COSMOSM
0 ~4 W0 q% R5 Z% E& JE:\cwwi\COSMOSM\cosmosmsetup.exe
$ D" e% a9 v4 V/ S' f! G) `! |
And also dwgeditor, eDrawings, pdmwserver, swexplorer if need them... |
|
楼主
