|
|
楼主 |
发表于 2022-1-6 18:57:10
|
显示全部楼层
来自： 中国
# General Output Settings
6 a6 }) s9 a& q' B0 }% N4 C4 M# --------------------------------------------------------------------------# n1 A) Y: ~: E; c, s! p
maxfeedpm : 500 #SET_BY_MD Limit for feed in inch/min2 m0 [& O; Z5 k/ n/ |
ltol_m : 0.05 #Length tolerance for arccheck, metric
6 N# Q- q0 k" O. I/ n* Vvtol_m : 0.0025#System tolerance, metric6 K3 X. c: K. c) v( n
maxfeedpm_m : 10000 #SET_BY_MD Limit for feed in mm/min; K: E* i0 |6 C. E' s# t
force_wcs : yes$ #Force WCS output at every toolchange?
. ~6 M ^# G. S. G6 T1 w: ^stagetool : 1 #SET_BY_CD 0 = Do not pre-stage tools, 1 = Stage tools
j$ R6 z" ?; hstagetltype : 1 #0 = Do not stage 1st tool
$ M# T b3 R" B$ t; { #1 = Stage 1st tool at last tool change; Q& E+ l2 b' }! [2 [
#2 = Stage 1st tool at end of file (peof)
7 ?, {& I7 G$ ^% S3 S/ V- g: @; fuse_gear : 0 #Output gear selection code, 0=no, 1=yes
3 P6 m' P; M5 N/ F E, Umin_speed : 50 #SET_BY_MD Minimum spindle speed9 u# Z/ g, [7 R' ^ u3 n$ P4 T
progname$ : 1 #Use uppercase for program name (sprogname)
. o9 \' t g+ b! k3 fprog_stop : 1 #Program stop at toolchange: 0=None, 1=M01, 2 = M007 `' C! Z6 ]& d$ }" i8 V
tool_info : 3 #Output tooltable information?
' \) N# P- `* R! \ #0 = Off - Do not output any tool comments or tooltable |
|
发表于 2022-1-6 18:53:58
