The GPPTool program can be run in one of two modes:8 b7 L9 @. B; w& X% ]
As an integral part of SolidCAM program. Whenever the G-Code command is given inside SolidCAM the GPPTool program is activated to generate the G-Code.
As a separate stand-alone program; It receives as input a Part generated by SolidCAM and then generates the G-Code. This program supports list of postprocessors. The user should make sure that the same CNC-machine is used both by SolidCAM and GPPTool. Run GPPTool by Double click on file named GPPToolExe.exe that is located on the following folder:
\\Program Files\\SolidCAMXXXX\\SolidCAM, `5 E4 O5 |' v1 Uwhere XXXX is the version of SolidCAM Software.# J0 k" n1 s# N
上面这段话大意是说后处理工具在安装在 \\Program Files\\SolidCAMXXXX\\SolidCAM，可是我的solidcam2011却只有一些后处理文件，没有执行程序。我的安装我看看了是没有问题的，是不是这个版本的solidcam2011 sp0没有哟，有没有遇到有过同一问题的哥们，来说说呀+ V6 S0 {2 ^7 K3 N# e" W
来源: solidcam后处理工具?
发表于 2016-12-27 12:37:54
发表于 2016-12-27 22:51:18