|
|
发表于 2010-6-7 15:49:49
|
显示全部楼层
来自： 中国香港
这个问题我已经请教过PTC的TS，对于3.0以前的版本（含3.0），组件中有多种形态的挠性化专配，如同一弹簧的状态不一样，则在工程图中，球标不能自动创建1 V, T- ~! a" t3 g/ s
处理办法：换更高版本或者手动添加球标. V# G# M2 `4 q! c; p4 }/ W6 p
4 Y; B- A4 y. m: ^标题 BOM Balloons Cannot Be Shown For Flexible Components.­) U+ B! T- I: t) o+ u) i# Y
详细信息
d# s: q: y3 ?& m4 f: b$ q( L% [说明
7 J& Q) o, @, M, w1 [" i9 Y4 m3 G5 k4 |In Pro/ENGINEER Wildfire, Flexible Components may be created in order to show the same model in different configurations. For example, a flexible spring may be modeled as flexible component so that the same component shows in different states. In a repeat region, flexible components are reported, but BOM Balloons cannot be shown for flexible components.1 ~3 G% F# s7 ~3 q
解决方案
( I$ \9 y5 O2 C. _This issue has been resolved in Pro/ENGINEER Wildfire 4.0. BOM Balloons can now be shown for flexible components.& {3 g) v$ X5 H0 q+ P; Q# g* N( |
备选方法
, v' R2 O* `8 z: B+ ?; _Create the balloon manually using menu option #Insert, #Balloon.: b6 N6 c) h" y4 ^& U) {
附加信息
7 k, ?7 N- X. R2 I# b/ fNo Additional Information. |
评分
-
查看全部评分
|
楼主