SW2009怎么立刻出了这个Service Pack 1.0 Early Visibility

a1s1

这么快啊，就有sp1.0(EV)了。网页上看到的sp1.0说明

Service Pack 1.0
Export to 3D XMLSave As 3D XML saves the file to the V4.2 specification of 3D XML.
Routing - Ribbon CablesYou can create folded ribbon cable routes. You can define ribbon cables from the cable/wire library, use the Auto Route PropertyManager to specify the path, and add ribbon cable connection points to connectors using the Connection Point PropertyManager.
9 ]2 q" n) f2 P# G3 i9 h: Y1 kFeaturesThe "Solid Sweep Cuts" section of the What's New book mentions the ability to create a solid sweep cut along a non-tangent path. This feature is not supported in this release.
4 R& a6 m& d/ f  e9 P3 T
$ [* g$ E7 F! K4 w. R! hService Pack 1.0
输出到 3D XML保存为 3D XML 会将文件保存到 3D XML 的 V4.2 规格。
  i3 l7 ~, y2 G- @; h# v( v/ \6 JRouting - 带状电缆您可以生成折叠的带状电缆线路。您可从电缆/电线库定义带状电缆，使用自动步路 PropertyManager 指派路径，然后使用连接点 PropertyManager 将带状电缆连接点添加到接头。

[ 本帖最后由 a1s1 于 2008-10-30 19:44 编辑 ]

qxzch

早点出SP1吧，SP0还是有不少问题