|
|
发表于 2008-1-10 02:21:35
|
显示全部楼层
来自： LAN
Guys!& U' }) T6 ~8 \6 z- L* c/ T5 B; Y
All you make a big mistake then allow to Install SolidWorks2008 using automatic SolidWorks Installation Manager (it is new feature in SW2008)
$ b' ?8 o F. O& N) h* vSolidWorks Installation Manager checks you SW-Serial and allow to install only that SW2008 configuration that registered for that SW-Serial..
7 z4 U" F, W6 `: P4 C
: }+ ~% v# I& G4 X; C) |8 L# uIt is funny but if you use a valid but not registered SW-Serial you will be allowed to install all you want manualy!
% d. s: i# T% ^5 G$ P
+ t' w2 C6 X& I8 l, c q& f8 @So the right way to inatall SW2008 is:9 o+ q0 F6 e4 x
1) Interrupt and Cancel SolidWorks Installation Manager working
h2 t8 A- V2 j" e2) Browse to E:\swwi\swsetup.exe (E: is a image of SW2008 SP0.0 5,4 GB ) and run it
1 g1 P$ ^8 O: V
6 B: |2 h! o6 h; d9 D6 BSo you can be able to install all SW2008 configurations ( as it was in SW2007)
& X! T5 ]. ~8 z, Y! b6 I& F! s4 R9 y9 `
In the same manner you can Install all СOSMOS: m# j- n# e' L4 m; b8 J
: {. V2 P1 h9 S% S2 I. ]0 q1 R5 p0 G" g
COSMOSWorks
7 V" o) |$ @) k S% FE:\cwwi\COSMOSWorks\cwsetup.exe; X( F0 G$ |4 `
' S8 `, o: i) \8 c$ [0 @* Z6 _
COSMOSFloWorks0 b9 g6 M1 }: s# o3 Q( E9 |/ }# P9 ~
E:\cwwi\COSMOSFloWorks\cfsetup.exe& `2 V: n7 E I( c" z
8 B7 b( g5 \! T% C3 n
COSMOSMotion
1 G7 f% J# T: PE:\cwwi\COSMOSMotion\cmsetup.exe
( r4 T1 u' L0 n" q# V: B
! Y7 t+ ? l( Z" G0 m4 `COSMOSM6 {. H5 K! U( c
E:\cwwi\COSMOSM\cosmosmsetup.exe0 f, c4 S" P- ^6 ?
5 l8 ^( [) C( g7 J+ F
And also dwgeditor, eDrawings, pdmwserver, swexplorer if need them... |
|
楼主
