|
|
马上注册，结识高手，享用更多资源，轻松玩转三维网社区。
您需要 登录 才可以下载或查看，没有帐号？注册
x
TOOL CHANGE: FIRST:
2 p2 ?$ F3 _& D7 D: S. p: r SET_ON SPIN_SPEED SPIN_DIR ;
7 v* v8 X H3 n) H2 S8 ^ ?*-----save first tool number / e! N3 Q J6 a, B
FirstTool = CURR_TOOL ;
; d4 ~# E- T" R LastTool = CURR_TOOL ; & i! T3 S( J4 h: x: [+ @7 D
7 }" @+ y' Q/ N# I9 t- v*-----tool cutter compensation register number
# p( G3 R. |; W8 f8 k* R" Z CutterComp = CURR_TOOL + DiaComp ; - g! W! b, `0 w! j, K- L( Q- ?
: {" h+ y [% v8 D; J+ e" F*-----assuming 1st tool is in the spindle, there is no need
# L: }: v# N% g6 M* for tool change)
4 j) y& [% f+ B8 w0 N Z4 Q* OUTPUT $ " T" CURR_TOOL ; 7 M' _4 S4 V8 m/ {# N
*-----more then one tool in this run of the Post Processor
' W; |/ d! |% M1 p8 D6 Z0 g IF_SET (NEXT_TOOL _NE_ CURR_TOOL)
2 w) ]% H+ \! | OUTPUT $ " T" NEXT_TOOL ;
; }! V$ w$ ^! O( O; Q. m7 c- m# n END_IF ; + O' ^- N$ f- t1 t; w
*-----standard tool change commands. (assuming 1st tool is in # n; r2 q8 \/ ?2 f
OUTPUT $ " G90 G80 G00 G17 G40 G54" ; . h+ s) f. e/ I/ @: C3 c1 h
OUTPUT $ " Z" Zhome " S" SPIN_SPEED " " SPIN_DIR ; o: M& t3 R: L b& n) N g
OUTPUT $ "( 刀具名称---" CURR_NAME "×" CLEAR_LENG ")"; - `* |; S' _% _3 V7 ~6 a
OUTPUT $ "( 曲面偏移=" PART_OFST "曲面公差=" PART_TOL" 轮廓偏移=" CONT_OFST " )";( ~1 K3 o4 V$ ^; [4 y% {, j- s
OUTPUT $ "( 程式名称=" TP_NAME "本程式由" USER_NAME "编制 )";: e( ^4 H: s. E f" l7 {7 W* Z( G
" I/ ]8 z, l8 ^ G5 g
% z% ^4 m: I- z9 n' ^8 t 说明：1、*注释或代表不执行此内容；
1 m, x; Z. ~ J u' q 2、 引号里内容则按实输出；7 X% } P6 v$ W1 p: G
3、修改保存完毕执行主菜单--NC--DFEXF--输入后处理名--回车即可。 |
|
发表于 2007-12-14 17:18:02