|
|
发表于 2013-3-21 08:44:29
|
显示全部楼层
来自： 中国广东广州
本帖最后由 kevin1985 于 2013-3-21 08:50 编辑
% n, A! V$ z- H( h5 N/ \1 S) n' B6 U, {$ w
一般用在加工中心里面的，看下图就是一种
7 e( Y5 I( O% T: V/ ?Contouring heads transform a horizontal boring mill’s W-axis quill motion into radial cutting edge motion, Inside each tool is an actuator shaft with an inclined key that precisely mates with a slot in a tool slide. Quill extension pushes the actuator shaft and causes the tool slide to move outward, increasing the diameter of the rotating cutting edge. Quill retraction decreases the cutting diameter.
: P' s. ^6 _; Q* u( G |
评分
-
查看全部评分
|
楼主