|
|
楼主 |
发表于 2009-1-26 09:56:09
|
显示全部楼层
来自： 伊朗
I had no success running HSM on this system." v" l! }0 n6 M$ I
I just installed v3.0.53.15030 and here's the result.
" W; D4 U) D: _& \3 q8 N
! Y: \5 ?. y% n& M* T6 n: n) L/ FI tried exporting geometry as STL and used it as "Geometry Source" in a parallel finish Operation.' t: Y8 Y4 M) G v& c4 R
: O, t! B- |# cHere's the system message.2 p2 \8 n7 a+ O8 L, I7 u& E
" N. K* J8 d7 v
Information: Initializing parallel finishing strategy
( v2 C* f7 F4 l+ C, m8 C$ |Information: Ignoring associated geometry due to explicitly selected stereolithography source.; i# E( O) Y4 o& Y7 \
Information: Using external stereolithography file:///D:/U/GEOM.STL (4.9Mb).2 c9 w- i" V' g
Error: Floating-point operation on denormalized operand at address 0x0b9c886d.
( x2 a j2 O& U
, o) u& z& o) f% H* t8 D
% d2 [. a& Q! d2 W6 T1 w# JMaybe the cr@ck only works for dual core systems??2 }4 s6 U0 X2 k' V6 M$ ]
: v2 D( s E. L3 v4 S- @* F! bOn other dual core systems it works fine. 
! `' r$ Z5 S YAny help will be much appreciated.1 s2 b3 H0 ^: R' Q% M
. k/ k2 }: E$ V0 i$ {3 `5 s5 }
[ 本帖最后由 ccuappz 于 2009-1-26 09:59 编辑 ] |
|
发表于 2008-12-17 00:37:08
1楼的，我也是用的这个版本的，X3MU1上都是可以用的啊，老大的那个CRACK是可以在5.1上用的
)19*( 告诉你另外一个原因就是HSM必须和网络北京时间对应，否则无法工作