AIAG CQI-9热处理系统评估HTSA(Heat Treat System Assessment) 审核表格-中英文

daviddzj

AIAG CQI-9热处理系统评估HTSA(Heat Treat System Assessment) 审核表格-中英文.pdf
5 o8 l2 R6 X/ ~Heat Treat System Assessment (HTSA) Update
热处理系统评估(HTSA)更新

6 ~4 Y+ d' O& z
The International Automotive Oversight Bureau (IAOB) has recommended that Heat Treat System Assessment (HTSA) auditors become familiar with CQI-9 and include verification of supplier compliance when conducting these audits.This verification should be included in audit plans by the end of 2006.
国际汽车监督局(IAOB)建议,热处理系统评估(HTSA)审计员熟悉CQI-9包括核查供应商履约进行时,这些审计结果. 这项核查工作应列入审计计划,2006年年底前结束.
# r1 |! }: w% K4 Z% w0 M9 d$ P
1 i! x8 }) c- q  W- t
The goal of HTSA is to develop a heat treat management system that provides for continual improvement, emphasizes defect prevention and the reduction of variation and waste in the supply chain.HTSA provides a common approach to a heat treat management system for automotive production and service part organizations.
: f# A7 L+ p2 ^8 V# {HTSA的目标是制订热处理工艺管理体系,为持续改进强调缺陷预防,减少变异及浪费的供应链. HTSA提供了一个共同的方式,以热处理工艺管理系统,用于汽车生产和服务组织的一部分.

Unless otherwise specified by customers, future requirements indicate that assessments must be conducted annually to re-examine the continuing compliance with the HTSA.As part of the on-going surveillance audit cycles, corrective actions are required for any unsatisfactory areas.
除非法律另有规定,客户未来的要求表明,评估工作必须每年进行一次重新审核继续遵守.作为上持续监视审计周期,纠正行动所需的任何不理想的地方.
- u: k5 y% U: d  h4 P3 r
8 s/ l5 ^- F+ K# a/ d$ s: v2 PMany North American Original Equipment Manufacturers (OEMs) consider this to be a "Customer-Specific Requirement" and expect compliance from any ISO/TS 16949 registered companies.
- A/ ], _7 b; W1 b( J许多北美原始设备制造商(OEM)认为这是一种"以客户的具体要求",并期望从遵守任何ISO/TS 16949注册公司.
$ H" G& s2 V8 f$ ], I, K) V* k
[ 本帖最后由 daviddzj 于 2007-12-23 10:20 编辑 ]