|
|
楼主 |
发表于 2023-6-5 08:21:47
|
显示全部楼层
来自： 中国广东梅州
" P1 o, D, ^: C4 i( L' d; c
和谐文件可以上传？？？1. Install Mastercam X7-202X 64-bit. Do not start Mastercam.
+ P/ Q/ q% @/ v$ O! e3 h @7 W2 [1 Z" j1 c0 C5 y1 v- R/ S
2. Install MultiKey_18.1.1_x64
- q3 M# b1 B X3 G+ b7 j
8 G) ^3 q- i2 [8 u# h7 n- `2.1. Uninstall Multikey 18.1 Win64 (if exist) a* L7 @" i$ ]
e$ k% w$ Z n% h/ L2.2. Copy folder "MultiKey_18.1.1_x64" on computer' y+ x \3 `" m* s3 `
6 A# J6 v5 B) @! L9 e' |1 A3 e
2.3. Run as Administrator "MultiKey_18.1.1_x64\remove.cmd"" ~8 O! d, Y% a/ C5 N3 K. ^
7 F+ S% C8 R% `' ?2.4. Run as Administrator "MultiKey_18.1.1_x64\install.cmd" and wait until the end of setup$ T4 O1 Q+ c' a2 E8 K0 P
1 d e/ B9 ~- L2.5. REBOOT computer!- T& Y1 [/ l$ z* t9 M5 k
: m4 K/ v* X" B0 |) `8 P( V# q
3. Enjoy
: V# E. a0 ?- N' g e. ]9 q3 n
! {: B. b, [- I m: Y7 @1 z& t( F. b
NOTE: If you want to use SolidCAM or Imachining for NX on the same computer with Mastercam; P" l, Y/ y0 l$ u1 H: v
run "MultiKey_18.1.1_x64\SolidCAM.reg" and repeate steps 2.3-2.5
) B- T: R/ C! E. g2 t: n1 G; ^5 ]0 d9 O2 J7 k
; X1 V5 R& H- k# O2 R& w# E
. M0 {: U* z- X6 j5 B) L
, Z# `' F! P7 ?0 m) oCracked by TeAM SolidSQUAD-SSQ
4 M- j. L+ d0 ^, `5 S4 q s! s
6 B' L$ P" i, x, k7 q; G
" ~' m' N* x3 b0 R5 B) A |
-
|
发表于 2023-6-1 12:53:33
发表于 2023-6-4 20:05:06