|
|
楼主 |
发表于 2022-1-6 18:57:10
|
显示全部楼层
来自： 中国
# General Output Settings Q" c4 I% A$ {
# --------------------------------------------------------------------------6 a4 V8 w( @1 d1 ^6 v$ e
maxfeedpm : 500 #SET_BY_MD Limit for feed in inch/min' e( M, C5 K) B/ v6 W
ltol_m : 0.05 #Length tolerance for arccheck, metric
9 G6 n/ a7 v0 V5 Wvtol_m : 0.0025#System tolerance, metric
T& x7 H" I% z5 [maxfeedpm_m : 10000 #SET_BY_MD Limit for feed in mm/min
8 i# X! [0 H/ K3 r; wforce_wcs : yes$ #Force WCS output at every toolchange?
% O5 }7 \6 J: G/ U& X, nstagetool : 1 #SET_BY_CD 0 = Do not pre-stage tools, 1 = Stage tools1 L: A1 u/ x6 n& |
stagetltype : 1 #0 = Do not stage 1st tool
2 m7 l9 h+ x% I; j* t #1 = Stage 1st tool at last tool change
7 g# w% X- g! r #2 = Stage 1st tool at end of file (peof)* w8 N" q. y$ R" }
use_gear : 0 #Output gear selection code, 0=no, 1=yes
. q; N9 P- @1 a$ x: Zmin_speed : 50 #SET_BY_MD Minimum spindle speed
4 C5 Z, j3 q, j5 s0 x+ D. O& w1 N; gprogname$ : 1 #Use uppercase for program name (sprogname)! U" d3 V4 `6 h' b, R4 ]6 [
prog_stop : 1 #Program stop at toolchange: 0=None, 1=M01, 2 = M00
+ H/ f# p2 F9 \* atool_info : 3 #Output tooltable information?
. L- n' {7 g% m' A, h+ N% t; X# G #0 = Off - Do not output any tool comments or tooltable |
|
发表于 2022-1-6 18:53:58
