|
发表于 2006-8-5 16:17:38
|
显示全部楼层
来自: 马来西亚
If you are refering two part in solid modeling:
, L3 W; x+ ?0 K) P6 h8 t" KThen select the part A as skeching plane first, then use command > filter, right click > filter\ line , select part B to focus on part A plane.
! `4 z+ A& U% ?+ f' \$ x
9 P% c0 \6 G# S. Q9 n- cIf you are refering two drawing in 2D drafting, even simple. ( Y# l- H) g& U& B
Just open part B drawing, select line to be copy/reference using CTR + C button. Then open out part A drawing, and used CTR +V to paste on the view that you want. |
|