|
楼主 |
发表于 2022-1-6 18:57:10
|
显示全部楼层
# General Output Settings/ p# J, m, ?$ h" g) b& ]
# --------------------------------------------------------------------------
0 u/ b- T5 ~& @6 qmaxfeedpm : 500 #SET_BY_MD Limit for feed in inch/min* A( ^2 y' T- c* s9 N
ltol_m : 0.05 #Length tolerance for arccheck, metric$ A) b1 H6 B) x
vtol_m : 0.0025#System tolerance, metric
4 V( z7 e$ I/ u5 E+ ymaxfeedpm_m : 10000 #SET_BY_MD Limit for feed in mm/min
# j' n' P: S0 [" ~, Kforce_wcs : yes$ #Force WCS output at every toolchange?% Z# v. t) o7 v; K7 E' X0 E
stagetool : 1 #SET_BY_CD 0 = Do not pre-stage tools, 1 = Stage tools
: l( c3 v$ c# e: u: h. |7 Estagetltype : 1 #0 = Do not stage 1st tool t, a) e8 e5 j( E) V- i! m
#1 = Stage 1st tool at last tool change3 `4 f! L: s$ h& b+ z( z
#2 = Stage 1st tool at end of file (peof)5 t( i3 F2 o ^ l
use_gear : 0 #Output gear selection code, 0=no, 1=yes
# {6 m4 e# H/ s3 O& |$ Y8 omin_speed : 50 #SET_BY_MD Minimum spindle speed
" I' ]* K& E' K" M: M7 t; ~progname$ : 1 #Use uppercase for program name (sprogname)" e! z7 w4 N y8 F- k8 A
prog_stop : 1 #Program stop at toolchange: 0=None, 1=M01, 2 = M00
- L# W; ], E- [: s' otool_info : 3 #Output tooltable information?% B4 a+ ]; W) r, }
#0 = Off - Do not output any tool comments or tooltable |
|