|
楼主 |
发表于 2022-1-6 18:57:10
|
显示全部楼层
# General Output Settings# ^* D9 F/ p# n- h& o' O
# --------------------------------------------------------------------------
! _! Z6 S2 S4 t: [+ ?maxfeedpm : 500 #SET_BY_MD Limit for feed in inch/min
) o9 ~1 N6 D. `( O' Sltol_m : 0.05 #Length tolerance for arccheck, metric
" t2 D; j9 j- a% A/ h8 z( i0 [3 vvtol_m : 0.0025#System tolerance, metric
! Z9 o7 b. {4 vmaxfeedpm_m : 10000 #SET_BY_MD Limit for feed in mm/min
8 ^8 [: m7 M! d) n$ m( ^' Uforce_wcs : yes$ #Force WCS output at every toolchange?
# }2 X# o' e* M* t" `" z% H0 Z& t5 Cstagetool : 1 #SET_BY_CD 0 = Do not pre-stage tools, 1 = Stage tools! w; U# m7 x6 E( x/ e
stagetltype : 1 #0 = Do not stage 1st tool
. S' }7 u3 i4 W5 A9 `% A3 u #1 = Stage 1st tool at last tool change
/ C4 {' K. V* X# {7 d" f #2 = Stage 1st tool at end of file (peof)
' |5 B/ J4 z& q: [/ L4 N: _3 c7 quse_gear : 0 #Output gear selection code, 0=no, 1=yes& T0 z7 c Y1 L4 f
min_speed : 50 #SET_BY_MD Minimum spindle speed8 H; d- O% u I! F. L; G
progname$ : 1 #Use uppercase for program name (sprogname)# O) [9 o1 _- s; U z
prog_stop : 1 #Program stop at toolchange: 0=None, 1=M01, 2 = M00% Z% {& m" C% z4 |5 z
tool_info : 3 #Output tooltable information?
: W4 J& J* d# |% E: f, D: D: T #0 = Off - Do not output any tool comments or tooltable |
|