三维网
标题:
关于cimatron后置处理
[打印本页]
作者:
sundengbin
时间:
2007-12-14 17:18
标题:
关于cimatron后置处理
TOOL CHANGE: FIRST:
3 n+ N4 L" p/ V6 w2 X
SET_ON SPIN_SPEED SPIN_DIR ;
& u& I, D( G8 P& b
*-----save first tool number
# B- A, B" G1 u
FirstTool = CURR_TOOL ;
1 A7 L! b% _* \0 R) m9 J" s
LastTool = CURR_TOOL ;
+ O: d! F' H8 P6 _
q, { Q" t7 Y0 w$ f D K1 F
*-----tool cutter compensation register number
6 U- D8 K- r- h6 ]( A/ f& _
CutterComp = CURR_TOOL + DiaComp ;
+ S- @+ g. B E) H+ _
- v: ]4 k$ |* M$ y/ p+ L
*-----assuming 1st tool is in the spindle, there is no need
# ^$ {$ a: Q& ?4 b; X; X/ ^
* for tool change)
$ h/ J0 ~5 h! h2 a/ {8 r
* OUTPUT $ " T" CURR_TOOL ;
. ]* z/ ?4 b+ i+ U3 p, M: r
*-----more then one tool in this run of the Post Processor
. R6 t5 b6 p+ M& q
IF_SET (NEXT_TOOL _NE_ CURR_TOOL)
2 O3 p( K# r, k6 d1 O) a( ?* H
OUTPUT $ " T" NEXT_TOOL ;
. Y1 E2 I- l' o# \' I2 y$ G
END_IF ;
g* E- J) Z! _5 C" ^3 @
*-----standard tool change commands. (assuming 1st tool is in
4 d$ ]) d( i" @' U
OUTPUT $ " G90 G80 G00 G17 G40 G54" ;
' H/ K+ J" W# u- ?& }- o) Q
OUTPUT $ " Z" Zhome " S" SPIN_SPEED " " SPIN_DIR ;
) k& H: h7 R8 v. r6 }! r$ a
OUTPUT $ "( 刀具名称---" CURR_NAME "×" CLEAR_LENG ")";
' q% K2 S8 Z; a; M
OUTPUT $ "( 曲面偏移=" PART_OFST "曲面公差=" PART_TOL" 轮廓偏移=" CONT_OFST " )";
5 m5 |0 {. u B, i2 Q4 J2 [
OUTPUT $ "( 程式名称=" TP_NAME "本程式由" USER_NAME "编制 )";
& E3 d( Z5 i+ H6 b% x4 A
@( ~5 b% z% `4 i! T
+ ]$ t* J( j5 T1 A& n- `, ?# f
说明：1、*注释或代表不执行此内容；
' d' y, V5 d. k
2、 引号里内容则按实输出；
! U6 r7 t: T* J# t8 z
3、修改保存完毕执行主菜单--NC--DFEXF--输入后处理名--回车即可。
欢迎光临 三维网 (http://www.3dportal.cn/discuz/)
Powered by Discuz! X3.4